CAN Protocol Implementation for Industrial Process and Tracking System

  Prashant. I,  Mr. Shrikanth Rao S K

To implementation of industrial parameter control through CAN protocol by using ARM processor. CAN is a multi-master broadcast serial bus standard for connecting electronic control units (ECUs).Each node is able to send and receive messages, but not simultaneously, a message (consisting primarily of an ID usually chosen to identify the message-type/sender and up to eight message bytes) is transmitted serially onto the bus, signal pattern codes the message (in NRZ) and is detected by all nodes. The devices that are connected by a CAN network are typically electronic control units, A CAN Message never achieves these gadgets specifically, however rather a host processor and a CAN controller are needed between these devices and the bus. Bit rates up to 1Mbit/s are conceivable at system lengths underneath 40 m. Decreasing the bit rate allows longer network distances (125kbit/s at 500 m). The programming language used for developing the software to the ARM processor is Embedded/Assembly. The KEIL cross compiler is utilized to alter, aggregate and investigate this system. Small scale Flash software engineer is utilized for smoldering the created code on Kiel into the ARM processor Chip. Tracking system implemented on sensor data by using the GSM

Keywords- CAN bus, ARM Processor, Complier, Sensors, GSM Module

Unique Identification Number - IJEDR1502165
Page Number(s) - 941-947
Pubished in - Volume 3 | Issue 2 | May 2015
DOI (Digital Object Identifier) -   
Publisher - IJEDR (ISSN - 2321-9939)

  Prashant. I,  Mr. Shrikanth Rao S K,   "CAN Protocol Implementation for Industrial Process and Tracking System", International Journal of Engineering Development and Research (IJEDR), ISSN:2321-9939, Volume.3, Issue 2, pp.941-947, May 2015, Available at :http://www.ijedr.org/papers/IJEDR1502165.pdf