Reduction of stacker tilting shaft and rollers breakdown

  M Balaji,  Veerabhadrappa Algur,  Shivakumar B

In this work where stacker is machinery equipment in Cut to length unit where the stacker tilting shaft and roller are bended and sometimes sheared if excess load is acted on it due to this the production of CTL unit goes down and quality of sheet is reduced and more scrap will be obtained and unsafe environment because the sheets will get bended in stacker in between rollers while operating because of tilting design problem so the bent sheet has sharp corner’s must be handled carefully handled . So after the Modification of stacker tilting rollers and tilting shaft design it reduces the delay time in stacker by 2hours for every tilting shaft change and there by achieving higher production rates. And Necessity of taking out the bended sheets are reduced due to less number sheets bend after modification and total operation time of machine is improved and safe work environment.

Keywords- CTL, Stacker, tilting shaft and rollers

Unique Identification Number - IJEDR1802099
Page Number(s) - 550-556
Pubished in - Volume 6 | Issue 2 | April 2018
DOI (Digital Object Identifier) -   
Publisher - IJEDR (ISSN - 2321-9939)

  M Balaji,  Veerabhadrappa Algur,  Shivakumar B,   "Reduction of stacker tilting shaft and rollers breakdown", International Journal of Engineering Development and Research (IJEDR), ISSN:2321-9939, Volume.6, Issue 2, pp.550-556, April 2018, Available at :http://www.ijedr.org/papers/IJEDR1802099.pdf